Ask Experts Questions for FREE Help !
Ask
    ultralog's Avatar
    ultralog Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 5, 2008, 07:53 AM
    Bryant 395C furnace does not kick on
    Everything is on, thermostat is set, furnace had been working but now it randomly decides not to turn. Now here is the kicker. If I turn off the power at the breaker and then turn it back on, or release the blower panel safety switch and then push it back in, or turn off the switch right at the furnace and then turn it back on, the furnace will kick in and heat up to temp. It could end up working fine for several cycles and then it stops working again.

    Any ideas?
    juggallojed's Avatar
    juggallojed Posts: 165, Reputation: 10
    Junior Member
    		  
    #2

    Dec 5, 2008, 09:32 PM

    Read the faq

    Find out the fault light status.

    Best guess would be a dirty flame sencor or a faulty pressure switch.. again that's just a guess with the limited info
    Phyllis3's Avatar
    Phyllis3 Posts: 1, Reputation: 1
    New Member
    		  
    #3

    Feb 5, 2011, 04:45 PM
    Ughh I have the same problem! It will work fine for a few days and then won't kick in... no warning, just a freezing cold house. I removed the front panel (bryant furnace) and there are no lights displaying a problem. There are no lights at all. Where are these light "status" things located that everyone tells me to check? Damnit I can't afford a service call:( Furnace is 5 yrs old, filter changed once a month. Works just fine then stops working. *sigh*
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant Furnace model 383KAV won't kick on [ 10 Answers ]

I'm not getting any error led blips from the computer board. I can only see one limit switch which isn't tripped. I replaced the thermostat but that wasn't it. I've checked breakers and even tried tripping them off and then back on. Usually if I remember right this furnace goes through a...

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

Furnace lights but won't kick on [ 2 Answers ]

Furnace lights but won't kick on

Furnace will not kick on [ 1 Answers ]

My pilot light is lit but my furnace will not kick on?

My furnace will not kick on! [ 1 Answers ]

My furnace will work regulary sometimes, but sometime it does not kick on by itself you have to turn the thermostat to off then back on and then it will run until it meets the tempature setting. But then when its time for it to kick back on it does the same thing. We have replaced the thermostat 3...

View more questions Search