Ask Experts Questions for FREE Help !
Ask
    ronlee's Avatar
    ronlee Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 1, 2008, 03:39 PM
    Cutting corian
    I would like to replace a drop in stove top with a larger unit and need to enlarge the opening
    Can I do rhis by using a router,do I need a special bit to cut the Corian?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Dec 1, 2008, 05:51 PM

    Treat Corian like a hardwood. A router can do the job but its best to finish the cut and clean it up with a router. You can cut it with a medium tooth saw or jig saw also. Put tape down on the top surface so your saw doesn't scratch any part that will show. Clamp or hot glue a straight edge on the surface as a router fence.\, the hot glue can be popped off later.
    kidolph's Avatar
    kidolph Posts: 90, Reputation: 12
    Junior Member
     
    #3

    Dec 2, 2008, 06:50 AM
    There are three other things you need to do.

    1. Even if you use a router to cut or clean up make sure that you sand out all toothemarks with 220 grit sand paper.
    2. Make sure that you leave sharp inside corners. make sure all corners are radiused.
    3. Use an aluminum tape, on the edge, to reflect and disburse any heat.


    I hope this helps
    Ken

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Cutting corian for an open hole [ 5 Answers ]

I'm trying to cut a hole about 7" diameter in a corian counter top to use for trash. How do I get a finished (smooth) edge like the edge of the countertop itself?

Cutting corian counter top [ 6 Answers ]

What tools and what method can I use to enlarge a corian counter top cut out for a cooktop. I need to enlage the cutout by about 5/16 in in one dimension and 3/16 inch the other. The couter top is about 1 inch thick.

Cutting a corian countertop [ 4 Answers ]

I need to enlarge the opening for a new cooktop in my corian counter by 1/2 inch. I've been told that I can do this with my jigsaw and a wood cutting reverse blade after taping the area to be cut. Is this correct? If not, how would I do this? I would prefer to use my jigsaw rather then a router...

Cutting through corian countertop [ 1 Answers ]

What is the best way to cut through a corian countertop. We bought a new slide in range - but this one is a couple of inches wider than our old one. The countertop has to be cut to fit in the new range. Can anyone offer suggestions?

Cutting installed Corian top for new oven [ 1 Answers ]

I need to cut a Corian countertop to convert a drop-in cooktop to a slide-in gas range. I need to remove the front section and slightly enlarge the cutout. How do I cut it without risk of destroying the rest of my countertop? Thanks, Erik


View more questions Search