Ask Experts Questions for FREE Help !
Ask
    framingham's Avatar
    framingham Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 23, 2008, 05:53 PM
    Briggs 16 hp Vanguard shutdown- B&S generator
    I have a generator with a twin 16 hp briggs. The engine starts right up runs fine for 14 minutes. After 14 minutes, it shuts down cold, & can be restarted immediately. It does not appear to be a fuel problem. I believe it is the low oil pressure shutdown function. If I disconnect the control board, it will run for 4 minutes prior to shutdown. How does one test this function. Since I am good about oil levels, this function is no more than "belts & suspenders" --If I can't fix it, I'd rather bypass it. Any advice on doing either?

    I have timed these run cycles several times. It has to be a function of the control board, I just don't know what type of input it is loking for.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
     
    #2

    Nov 28, 2008, 12:52 PM

    Hi,
    I seriously doubt the oil sensor to be at fault. At any rate you simply disconnct it as it only grounds out the ignition.
    My first suggestion is to replace the fuel filter since this is a maintenace item and check for improvement. It does sound like a fuel problem. They can fool you, happens a bit too quick to suspect ignition.
    Peace,
    Clarke

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs & Stratton 18 HP Vanguard [ 5 Answers ]

I am trying to fix a Toro 3100 Triplex mower used on a golf course. The machine has about 2500 hours on it. It is powered by a I am trying to fix a Toro 3100 Triplex mower used on a golf course. The machine has about 2500 hours on it. It is powered by a Briggs & Stratton 18 HP Vanguard V-Twin ...

Oil leak 16 hp vanguard briggs [ 3 Answers ]

Recently bought a trash pump with 16 hp briggs vanguard engine on eBay. Engine runs good no exhaust smoke but has bad oil leak or cylinder on same side as starter. I as Sume that the oil leak is a bad head gasket. How big of a job is it to change head gaskets. Thanks Maverick :confused...

Briggs & Stratton 16 hp Vanguard [ 2 Answers ]

Hello all, I have a this 16 HP Vanguard motor that came on a Dosko stump grinder. My problem is that the fuel will weep into the block and fill my cylinders. It also drips out of some sort of metal intake line that has nothing attached to it. This intake does suck air as it will kill the engine if...

Briggs Vanguard will not start [ 14 Answers ]

Briggs Vanguard, 15 hp OHV Model 280777 Type 0112.01 Code 94121154A Simplicity Brood Moor... The oil was checked and gas was checked prior to starting, the mower had been sitting for 4 to 6 weeks due to cold weather. I decided to started it and ran it at normal start speed until It warmed up....


View more questions Search