 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Baseboard heater
We bought a marley 2545 baseboard iwe connecting adopuble pole thermostat to it on the left endheater has 2 black wires the theromstat has a red and black wire and groung heater says you can wire to either end but the right end has a black and red wire how do I do this we are only wiring on heaterit is a 240 v
Help |
||||
|
||||
|
Follow the directions here.
http://www.berkomeh.com/develop/prod_pdf/2500wiring.pdf You may need a electrician to run additional circuits. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
How do you hook up a wall thermostat to a 220v baseboard heater, when the 220v feed goes to the baseboard heater first?
I have a room which has three baseboard heaters controlled by one thermostat. Two of the smaller heaters did not warm at all. The remaining one heater ( the largest) is always on. The fuses were removed ( one side was extremely hot) and the heater cooled down. The thermostat single pole was...
Hello, I tried wiring a 240v baseboard heater using a double-pole breaker and single pole thermostat. I connected both white and black at the breaker, paid attention to line/load using the black at the thermostat, wire nutted the white, and connected at the heater per instructions. When I...
I'm wiring a 240v 1500w heater and I ran a #12 wire because the circuit is also going to double as a A/C circuit for the summer. Anyhow I followed the wiring diagram on heater and wired to a 2pole 15amp and I turned on breaker and it popped so I pulled apart the heater and looked it all over again...
I have to replace a missing baseboard heater 110 volt 1500 watt all I can find at home depot Lowe's etc is 220 volt can I use one of those hooked to 110 I do understand the output would be lower but actually don't need that much heat in that room anyway Thanks Gene
View more questions Search
|
