Ask Experts Questions for FREE Help !
Ask
    rlwilson4318's Avatar
    rlwilson4318 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 22, 2008, 06:59 AM
    Evcon Model#BGM10016B
    I have an Evcon BGM10016B forced air furnace that was working well up until this morning. I noticed my house was getting colder so I turned up the thermostat but nothing happened. I can usually hear the unit come on but this time there was nothing. I checked the fuse in the unit and it is still good.

    Please help. It's the coldest day of the year so far.

    [email protected]
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Nov 22, 2008, 12:35 PM
    Power on to furnace from breaker?
    Filter clean?
    Reset unit by turning power on and off?
    Set thermostat to heat?
    Try turning on fan on at thermostst to see if fan runs? This will test for power at furnace.

    Post back with results.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman evcon furnace model no. DGU10014UB troubleshooting [ 11 Answers ]

Coleman furnace referenced in subject line ignites, getting gas, blower starts, runs for a couple minutes, unit shuts down, red LED light on board blinks ten times. Anyone know the code for this repair? I'm FREEZING! :(

Coleman evcon furnace [ 5 Answers ]

My home has coleman evcon furnace 12 years old.I can set the thermostat at 74 degrees and the furnace will start with a 30second purge then the ignitor will warm up and glow red then the main burner lights.then the burner stays lit and the blower runs for a couple minutes. Then the thermostat calls...

Coleman evcon [ 1 Answers ]

Furnace won't ignite the starter blower runs but nothing else happens

Coleman evcon burner on and off [ 1 Answers ]

I have a 1993 coleman evcon furnace model BGD07512AX. When I get a call for heat my blower comes on right away. Then my hot surface ignitor gets red hot. Then my blower comes on for 3-5 seconds and shuts off. This happens 3 times then furnace locks out with a retry alarm. Can anyone help me? ...

Coleman evcon [ 2 Answers ]

Fan won't come on in heat position

View more questions Search