Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replacing a mercury thermostat for a Hunter Model 44110
[ 3 Answers ]
I have just purchased a Hunter Programmable Thermostat Model 44110. I have taken out the front panel off my old thermostat and notices that my wires are red, white, yellow and green. The panel for the Hunter 44110 has the connections for G, Y, W and the RC and RH have a jumper. What do I do with...
Connecting Hunter Model 44110 Digital Thermostat
[ 4 Answers ]
I have a 15 year old house, with an original heating/AC system. I hoped to connect a new Hunter 5+2 model 44110 digital thermostat, but have run across one problem. The old Trane Thermostat has this information on it - Model AY28X105 30Volts A.C. 1.5 AMP with 5 wires, labelled G, Y, W, R, 2...
Replacing a mercury thermostat with a Hunter Model 44110
[ 1 Answers ]
I purchased a Hunter Programmable Thermostat Model 44110. I have removed my old thermostat and the wires it was connected to included red, white, yellow, orange, blue and green. The panel for the Hunter 44110 has the connections for G, Y, W and the RC and RH have a jumper. What do I do with my red,...
Hunter 44110 message
[ 2 Answers ]
I keep getting a message on my thermostat that says reco. If I hit the return button it goes away. But it just comes back later. What is it?
Hunter thermostat 44110
[ 2 Answers ]
I have hot water baseboard heat, and installed the hunter digital thermostat 44110, and followed the directions as directed, I had had wires W, Y and RH, I marked and installed Each of the wires, and put them where they were marked on the thermostat. I felt well and all of the lights ( temp,... View more questions Search
|