 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have the tile intalled and will be installing the carpet up to it. The border will be 11 feet long and runs across part of my basement from wall to wall. I would like to just butt the carpet up to the tile and tuck it in without using threshold which would visually separate the two areas. My...
So, I know that you can use an end reducer to transition the laminate to carpet - but my question is if you can do the transition with a tack strip (for the carpet) only. a.) Will the carpet fray too much if it isn't covered w/ an end reducer? b.) Will the will the last line of laminate...
Where should the transition between wood and tile take place between the Reading Room, Guest Bathroom and Guest Bedroom in the below floorplan? Note that the tile in the Guest Bedroom and Bathroom is the same tile and that the wood flooring runs from the Master Bedroom, through the diagonal hallway...
I will be tiling in my basement, on a concrete floor. Would it be better to install backerboard under the tile to bring it up 1/4" or 1/2" to make the carpet/tile transition easier? Or should I lay tile on concrete floor and then transition it from that height? Any suggestions would be helpful. ...
I'm laying tile in my bathroom where there used to be linoleum. The floor butts to carpeting and I've been told I should use a metal strip between the two surfaces. I bought the strip and have cut it to fit but my question is how do I adhere it down? It looks like I could screw it down or...
View more questions Search
|
