Ask Experts Questions for FREE Help !
Ask
    alogan36000's Avatar
    alogan36000 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 8, 2008, 05:00 AM
    Reignite Water Heater
    My water heater went out and I have been trying to reignite it for 3 days now. It is the newer version so we have a red button with a twist around key with off on and pilot on it. It is saying to hold something for 1 minute. I have been holding the red button but it still is not working. Please help me out?
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #2

    Nov 8, 2008, 08:05 AM

    Defective thermocoupling. Replace. Thermocoupling is the probe in the pilot light flame, with wire going to gas valve. Wire looks like a very small tube but is really a wire.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

New hot water heater installed, but no hot water pressure. Plenty of cold water? [ 11 Answers ]

Hi, I own a small plumbing service and have a problem I've never encountered before. I installed a new top vented gas water heater for a customer. Turned the main back on, bled air out of the lines, etc. Problem is there is no hot water pressure throughout the house. Cold water pressure is fine....

Need help deciding between a tank or tankless water heater [ 19 Answers ]

Which one saves me money; the tankless water heater or conventional tank water heater? :confused:

Surging water pressure & leaking water heater relief valve [ 19 Answers ]

Just recently the pressure of our water in the house surges when we turn a faucet on, and the city water company verified that our pressure in the house when we open a faucet is higher than the pressure in the lines in the street, and after the water runs is at a normal pressure (meaning their...

Water heater hookup with sidearm supplimental heater [ 0 Answers ]

Hello: I'm hooking up a sidearm heater to an existing electric water heater for use with an outdoor wood furnace. I've seen diagrams showing the upper port of the potable water side hooked up to the anode port, the TPV port, and the cold water inlet port. My initial thought is that plumbing it into...

Connecting a tankless water heater and separate hot water heater [ 6 Answers ]

What I have is this. An oil fired boiler that generates hot water for my house baseboard heating system. Contained within the boiler is a tankless heater that is heated by way of the firebox in the boiler. The tankless heater is used only for domestic hot water. It has a separate CW supply to the...

View more questions Search