Hinged shower door (framed) bottom clearance

jtflattery Posts: 1, Reputation: 1

New Member

Nov 7, 2008, 08:27 AM

Hinged shower door (framed) bottom clearance

What is the recommended clearance (bottom) for a hinged framed shower door

ballengerb1 Posts: 27,378, Reputation: 2280

Home Repair & Remodeling Expert

Nov 9, 2008, 07:29 PM

Zero, they usually use a rubber sweep gasket that makes a slight contact with the threshold.

Add your answer here.

Check out some similar questions!

Exterior wooden door clearance [ 3 Answers ]

This is a wooden "exterior" door on a brick windowed porch. Porch to house. In some areas I have less than 0.005" clearance. What clearance should I shoot for when sanding the door? 0.010? It might wait until spring.

How to adapt garage door bottom to driveway slope? [ 2 Answers ]

I have just had a roll up steel door installed on my old (1924) garage. Because the driveway is sloped from left to right (looking from the front of the garage) there is a 3 1/2 inch gap on the far left side between the garage door bottom and the driveway. This tapers down to nothing about 14 feet...

Can shower door be hinged to glass panel without a header? [ 2 Answers ]

We've been getting estimates on a shower door enclosure and are getting all sorts of different opinions regarding our configuration. It will be an L-shaped enclosure with a 33in panel on the short end of the L, and a door hinged to a glass panel on the other. (The door cannot hinge to the wall,...

Bottom freezer door pops open [ 1 Answers ]

When I close my Kenmore refrigerator door (596.7523940--bottom freezer model), the freezer door pops open. How do I adjust door to prevent this from happening?

Building code door clearance [ 9 Answers ]

I'm remodeling a bathroom, and the sink/vanity will go against the wall adjacent the door, so I'm wondering how close I can legally put it to the door. The image below is my rough layout. Is there code related to how much clearance a door must have? The door opens to the outside, so obviously I'm...