Ask Experts Questions for FREE Help !
Ask
    rlo signs's Avatar
    rlo signs Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 4, 2008, 09:30 AM
    Mimaki cg60st plotter
    I have a mimaki cg60st plotter
    I am having an err43 current code pop up any body knows what that is
    Scleros's Avatar
    Scleros Posts: 2,165, Reputation: 262
    Hardware Expert
    		  
    #2

    Nov 4, 2008, 02:31 PM
    The user manual for that plotter available in the Support section of Mimaki's web site states "An overcurrent in the motor in the widthwise direction of the sheet has been detected." for that error code. The suggested solution is "Turn off the power to the device once. Then, turn it on again. If the same message reappears on the LCD, contact your distributor."
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Mimaki Cutter Plotter CG-60 "Err20 I/O" [ 3 Answers ]

Hello there, I´m looking for some help about a problem in my Mimaki CG-60st. It always gives me the error message "Err20 I/O" when I press the REMOTE key and when it´s connected (serial) in the computer. The strange thing is that it works only in specific computer but when I connect it to any...

Mimaki cutter plotter CG-60st [ 10 Answers ]

I have sent a few messages to Mimaki CO for cutter plotters regarding my plotters problem, but with no reply! The problem is; the plotter’s LCD showing error “ERR41 Motor2”, obviously it says there is malfunction in motor2, the device is too simple: there are two motors with build-in sensors and...

View more questions Search