Ask Experts Questions for FREE Help !
Ask
    xshirlx's Avatar
    xshirlx Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 4, 2008, 06:58 AM
    Gas fires
    My gas fire lights then goes out and won't come back on
    EPMiller's Avatar
    EPMiller Posts: 624, Reputation: 37
    Senior Member
    		  
    #2

    Nov 4, 2008, 05:09 PM

    Oh.




    You HAVE to give more information than that or you'll never get any answers. Furnace? Fireplace insert? Other? Pilot light or main flame? LP or natural gas? Describe the problem FULLY and you will get intelligent answers.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Civic '89 fires up and dies down after 2 sec [ 6 Answers ]

Hi, I have Hona Civic '89. I had intermittent start up problems on hot weather recently so I replaced the distributor cap, rotor, and coil (I think this was the fault) and it worked fine after that. After about three week of good starts now it will fire and engine turn but then dies down after...

Only fires on one plug [ 1 Answers ]

Please help I have a 16hp briggs&straton vanguard v twin It is only firing on one cylinder I have no spark on the one side I have changed both magneto and still no spark. I don't know what to check now. Please help me out Thanks Bob

Carb back fires [ 1 Answers ]

I have a hand me down mower and it backfires through the carb. Also dies when engaging the blades.

House fires [ 4 Answers ]

I see some house fires were started at the outlet. They caught fire. I don't know the circumstances on each case. But can a outlet catch fire if nothing is plug into it??

Furnace 'fires' Blower won't engage. [ 5 Answers ]

This problem just started. Hile furnace w/ST9120B fan board will start up normally but blower no longer engages. Limit switch then of course shuts it down after a period. Previous posts do not really address a solution or diagnostic check to this issue. I do understand electrical/electronic...

View more questions Search