Ask Experts Questions for FREE Help !
Ask
    lawster144's Avatar
    lawster144 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 15, 2008, 10:18 AM
    Goodman furnace problems
    I have a Goodman furnace, its about 4 years old. The furnace starts up and the flame ignites but then after 2 seconds it turns off and repeats the process over and over, starting and stopping. I have seen other postings with similar problems, and it was said to be the heat sensor and it justs needs to be clean. If so where is the heat sensor and what does it look like?

Check out some similar questions!

Goodman furnace problems [ 21 Answers ]

Hi - I have a Goodman GPM furnace. It works intermittently. I replaced breaker, thermostat, Control board and surface igniter. All appears well on start up sequence ; blower runs and igniter heats up and then turns off as no gas comes out. Control board codes says OK. Can anybody recommend what to...

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

3 yr old Goodman Gas Forced Air Furnace problems [ 10 Answers ]

If thermostat is set to 70-90 degrees the furnace burner and blower will run constantly and the temp never gets above 68 degrees in the house. I have a Lux programmable thermostat and was thinking of replacing it with a Honeywell. I have a new filter. Any ideas? The weather has been in the...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.