Ask Experts Questions for FREE Help !
Ask
    honkebman99's Avatar
    honkebman99 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 7, 2008, 10:02 AM
    Generator transfer switches
    I want to use dpdt p&s switches to transfer power to a generator during a power outage. Is this o.k/
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Oct 7, 2008, 10:20 AM

    No, buy a transfer switch panel.

    Transfer switches have to have internal mechanical mechanisms that will not allow the switches to fail with both poles shorted.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Generator transfer switch - enough for well pump [ 1 Answers ]

I have a 10hp 5600 generator that I want to connect to a "GenTran 20216 Manual Transfer Switch". It states that this transfer switch has 6 switches (rated 15 amps ea), a handle tie for one 2-pole circuit such as a well pump. My question is this - my well pump is 220 30 amps. Does two switches at...

Generator power transfer switch [ 1 Answers ]

Our power goes off on a frequent basis. If it is off more than 8 hr I need to power up with my own generator 8kw, to prevent spoilage and to run the well. My question is do you have to disconnect the neutral also and run the neutral to the generator or can the neutral be common to both power...

3 wire 220 connecting transfer switch to generator [ 2 Answers ]

I have a manual transfer switch that I want to use between my house circuits and my 5000 watt generator. I have 3 wire #10 receptical existing from the circuit box over to where my generator sets (it is exhausted outside). Can I use this 3 wire line to connect my transfer switch to my generator...

Transfer Switch & Generator Compatibilty [ 3 Answers ]

I have installed a manual transfer switch in my home. It says in the instructions to make sure the neutral is un-bonded to the generator. My Generator has a bonded neutral to the frame. What can I do to make the switch and the Generator compatible? Thanks

Complex Service Entrance/Generator Transfer App [ 24 Answers ]

Information: 1) Electrical engineering degree :) , but not an electrician :( , 2) need help understanding NEC requirements for this application, 3) will have commercial electrician help but want understanding of requirements beforehand, 4) there are no permits, no inspectors, no code requirements...

View more questions Search