Ask Experts Questions for FREE Help !
Ask
    crazygranny's Avatar
    crazygranny Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 3, 2008, 03:58 PM
    Adjusting fan control on janitrol furnace
    I have an lod janitrol furnace and would like to circulate air in my house when the wood burner is going to heat the basement. I have looked all over the net and can't find any information on adjusting or wiring on just the fan control to help circulate warm air throughout the house. I don't want to have to light the pilot light any sooner than possible to heat house when I have a wood burner to do that but would like some heat in basement. Any advice,instructions,or manuels on this qustion would be deeply appreciated. I believe the furnace was installed in the 60's if this helps.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Oct 3, 2008, 05:25 PM

    Do you know if you have a high or low voltage thermostat?
    crazygranny's Avatar
    crazygranny Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Oct 4, 2008, 03:58 AM
    I don't know. How do I tell if it's a high or low voltage thermastat?
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #4

    Oct 4, 2008, 06:59 AM

    How many wires are coming into the thermostat? And what size are they.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #5

    Oct 4, 2008, 01:35 PM
    Does the control have a white push button? If so push it/pull it? And the blower will stay running.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Janitrol furnace won't ignite [ 1 Answers ]

I just replaced the flame sensor on my janitrol gmp050-3 and it still won't fire up to produce heat. It does everything but ignite please help it is cold and miserablein the house. Don't know what elese to do.:confused:

Janitrol Condensing Furnace Igniter [ 1 Answers ]

Hello, What would cause an igniter glow plug to try and light the gas when the cooling is running? I had a problem with a clogged condensing drain and was leaking water out of the overflow drain next to the condensate line, this water made it's way down through the furnace to the floor. The...

View more questions Search