Ask Experts Questions for FREE Help !
Ask
    themike320's Avatar
    themike320 Posts: 3, Reputation: 1
    New Member
     
    #1

    Aug 25, 2008, 11:22 AM
    3-Way, Combination 3 Light Switch
    Hello,

    I am currently trying to replace light switches that are quite old. The one I am stuck on is I have a 3-way combination 3 switch light switch that I'm stuck on. The older version had 9 wire spots. I cannot find a 3 way combination 3 switch to purchase so was wondering if there was anyway to use a regular combination 3 switch or anything that I could do?

    Thanks
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
     
    #2

    Aug 25, 2008, 01:44 PM
    Are these 3 single pole switches in 1 device to control 3 different lights?
    3 way switches allow turning on and off from multiple locations.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
     
    #3

    Aug 25, 2008, 01:55 PM
    Is this it?:
    Westside Wholesale, Inc. - Leviton Decora Three Rocker Combo Switch, Commercial Grade, Single-Pole - White
    themike320's Avatar
    themike320 Posts: 3, Reputation: 1
    New Member
     
    #4

    Aug 25, 2008, 09:38 PM
    Yes that is the one that I am trying to switch to, the old one had 3 different lights it was working for, one was only in the one location and the other 2 you could turn on and off in two different locations. Does that make sense? So 2 spots that were working 3 way and one working just in the one place.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
     
    #5

    Aug 26, 2008, 04:41 AM
    Then it sounds like this switch:
    Westside Wholesale, Inc. - Leviton Decora Combination Double Switch, One 3-Way and One Single-Pole - White
    Start with the single pole connections, hot to one side(side with the jumper), and the light that is switched from 1 location goes to the other side.
    On the half of the switch with 3 terminals, the 2 travellers go to same colored screws.
    You will notice a jumper tha connects top and bottom half of switch. If this end of the 3 way is the "constant hot" end, leave the jumper, if this is the "switched end", then the jumper needs to be broke off, and connect the wire that goes to the lights controlled from 2 locations to the common of the three way.
    themike320's Avatar
    themike320 Posts: 3, Reputation: 1
    New Member
     
    #6

    Aug 26, 2008, 10:43 AM
    I need one just like that but instead of only one 3-way outlet I need 2 and the one regular one like that. This is an upstairs light switch- the 2-way is for a closet and the two 3-ways are for hallway lights on each side of the switch. Do you know of anywhere that sells that kind of switch?
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
     
    #7

    Aug 27, 2008, 04:21 PM
    I may know of 1 supplier, try to find tomorrow. If this is a 1900 Box, with a single gang mudring, you may be able to carefully replace with double gang for 2 devices.
    If the closet is on the other side of the switches, you may be able to put closet switch on the inside of closet, should this triple switch not be found.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Installing a combination light switch [ 1 Answers ]

We have recently purchased this house and are replacing light fixtures which have pull strings to turn them in. I want to install a combination switch to a new fixture but I am not sure if this will be possible. I have 1 wire which is bringing power to that area. I am confused as to the best...

Can a 20 amp light switch replace a 15 amp light switch? [ 1 Answers ]

Can a 20 amp light switch replace a 15 amp light switch?

Change Pilot Light Switch with a Single-way Switch [ 1 Answers ]

It's worth noted that I am a complete novice, so please be patient with me. I want to replace an existing pilot light switch with a single-way lighted switch. The existing setup has four terminals (red wire, black wire, white wire, and ground wire). The red wire goes to the left, the black wire...

Combination switch and receptacle? [ 2 Answers ]

How do I install a combination switch and receptacle. I presently just have a light switch? Thank You.

One Switch two lights - the second light furthest away from light won't turn off [ 4 Answers ]

One Switch two lights - the second light furthest away from light won't turn off but the first one does Worked until I swopped the roses. Suspect that didn't do something right when putting them back. Up to now - left bulb out but need to get it to work now.


View more questions Search