[dhosinski]

Hello:
I've been reading though some similar threads about my Senseon dryer. I've tried testing the fuse, thermistor (with hair dryer), and ran through the board diagnotitics. Everything tests fine, and points toward the control board. I select a mode (i.e. Normal, Perm Press, etc.) hit start and all I hear is the main relay clickand nothing. I can't get to the motor to see if there's any power getting to it. I've done a test of the P3/P4 connectors with a DVOM in the DIODE TEST FUNCTION and depressing the buttons for each mode, plus the self diagnostic mode.

The manual says replace the board. Do you agree?

Thanks

Darrin

[ranks]

I Do Need Some Help With My Signature Washing Machine. Please. My Washing Machine Stop Draining I Did Change The Pump But It Still Don't Drain. Now It Has A Humming Sound Like It Wants To Do Something But Stops. Can It Be The Motor Or A Switch?

[dhosinski]

I think you needed to post under the "Ask" forum.. Just an FYI.

[dhosinski]

Hello:
I've been reading though some similar threads about my Senseon dryer. I've tried testing the fuse, thermistor (with hair dryer), and ran through the board diagnotitics. Everything tests fine, and points toward the control board. I select a mode (i.e. Normal, Perm Press, etc.) hit start and all I hear is the main relay clickand nothing. I can't get to the motor to see if there's any power getting to it. I've done a test of the P3/P4 connectors with a DVOM in the DIODE TEST FUNCTION and depressing the buttons for each mode, plus the self diagnostic mode.

The manual says replace the board. Do you agree?

Thanks

Darrin

Is there any point or connection I can place a meter across that is accessible to rule out the motor? I was reading about a couple of pins to read voltage?

Please advise...