Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Ducted heating control is reading room temp incorrectly.
[ 2 Answers ]
I have a vulcan ducted heating system, model no. 9255. The control unit is displaying the room temp as 35C when it is actually 11C or less. 35C is the max temp possible. As the room temp is displayed at the max temp, the heating will not come on as it its thermostatically controlled. I have...
Brivis EMS 20E heating unit
[ 9 Answers ]
Im wondering if anyone can help me, I have just purchased a home which has a Brivis EMS 20E unit. Every time I turn it on, it comes on for about 5 seconds, but then the thermostat inside says Error Code 41 (which apparently means overheating). It runs off a HSI pilot (but me being a girl I...
Water heater hookup with sidearm supplimental heater
[ 0 Answers ]
Hello: I'm hooking up a sidearm heater to an existing electric water heater for use with an outdoor wood furnace. I've seen diagrams showing the upper port of the potable water side hooked up to the anode port, the TPV port, and the cold water inlet port. My initial thought is that plumbing it into...
Wall heater pilot light lit, but cuts off when I turn heater on
[ 6 Answers ]
I have a wall heater, the pilot light was out so I re-lit it a couple days ago and it went on.. about 4 hours later I noticed it was out again... same thing off and on for three days... this time I lit the pilot and turned the heater on it immeditly made a click sond and went out completely... it...
Ducted Air conditioning - No Power
[ 4 Answers ]
My air conditioning recently stopped working. There is no power running to the wall switch but the fuses at the power board to the house are fine. The furnace is in a closed area without access so I haven't been able to check the control board without cutting a hole through the plaster wall. Before... View more questions Search
|