Ask Experts Questions for FREE Help !
Ask
    emoxray's Avatar
    emoxray Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 9, 2008, 04:51 PM
    3 wire connection to a new stove
    I am trying to connect a new stove with a 3 wire connection. It's a tappan and the burners come on but the indicator lights do not, nor does the clock. I believe I followed all the directions, but maybe not? Any hints.
    Credendovidis's Avatar
    Credendovidis Posts: 1,593, Reputation: 66
    -
    		  
    #2

    Aug 10, 2008, 05:19 AM
    Hello emoxray

    Check the following links. One of these may be able to help you :

    Tappan Stove Appliance Parts and Repair Help

    Tappan Support, Troubleshooting & Customer Service by FixYa

    Range & stove repair manual online - DO-IT-YOURSELF

    Success !

    :)
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #3

    Aug 10, 2008, 07:42 AM
    2 outside post are for power and the center post is for neutral
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Convert Four Wire to Three wire for stove [ 12 Answers ]

Hi. I had a four wire circuit from a dryer that I needed to convert to a NEMA 10-50R for my new Whirlpool electric range. I wired the new receptacle with two hots a and GROUND and capped off the neutral. I tested from the hots to the ground and I get 120V. From hot to hot I get 240 Volts. The...

Wire for electrical stove [ 10 Answers ]

Hello can you tell me what size # wire I need for a 220 that an electrical stove will run off? The breaker is a double 50. I think that the wire that is there now is too small for the breaker. I think that when more than one burner is in use they don't work properly. One will cool down while the...

Vintage stove- 3 wire 220v, what size wire? [ 1 Answers ]

We recently purchased a vintage Crosley range. The old wire was a 3-wire 220v, connected to terminals in the back- the black and red wires were actually 6 or so copper strands, and the white was a silver metal. My question is, what amperage do you think I need? Will 10 be enough? Thanks for your...

Stove hood Electrical connection [ 1 Answers ]

HI: I replaced a microwave with a stove hood. To connect the hood I used a 15V 14 gauge extension with a plug and exposed wires at the other end which I purchased from home depot. The receptacle which was used for the microwave is a 20 Amp with a 20 Amp breaker. Is the 15V extension OK? If not...

View more questions Search