Ask Experts Questions for FREE Help !
Ask
    ABCMORRILL's Avatar
    ABCMORRILL Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 5, 2008, 02:30 PM
    HUnter 44110 ThermoStat installed HVAC not work
    I tried to install Hunter 44110 programmable thermostat on a carrier hvac using the factory instruction. The ac will not work either compressor or fan. I tried to reinstall original carrier thermostat and ac will not run with it either. How do I correct the problem?
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #2

    Aug 5, 2008, 03:47 PM
    Did you disconnet the power to the unit before changing? If you didn't you either blew the transformer ot the Blade type fuse on the circuit board. Hpoefully it's a fuse. It will be either a 3 amp or 5 amp
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Connecting Hunter Model 44110 Digital Thermostat [ 4 Answers ]

I have a 15 year old house, with an original heating/AC system. I hoped to connect a new Hunter 5+2 model 44110 digital thermostat, but have run across one problem. The old Trane Thermostat has this information on it - Model AY28X105 30Volts A.C. 1.5 AMP with 5 wires, labelled G, Y, W, R, 2...

Problems wiring Hunter 44110 thermostat [ 1 Answers ]

I just bought a Hunter 44110 thermostat for an old gas wall heater. Only two wires came out of the wall and were unmarked (even the old thermostat didn't identify + and ground). I have read the instructions and connected one wire to ground and the other wire to RH. Note there is a jumper between...

Wiring a hunter 44110 5-2 programmable thermostat [ 1 Answers ]

Am trying to install a new programmable thermostat and I am having problems. My old thermostat had the following wires: white, orange, red, green yellow and blue. The new Hunter thermostat has places for RH, RC, G, Y and W. I have tried several different configurations and cannot get the a/c to...

Hunter thermostat 44110 [ 2 Answers ]

I have hot water baseboard heat, and installed the hunter digital thermostat 44110, and followed the directions as directed, I had had wires W, Y and RH, I marked and installed Each of the wires, and put them where they were marked on the thermostat. I felt well and all of the lights ( temp,...

Hunter 44110 Programmable Thermostat Wiring HELP! [ 3 Answers ]

My current thermostat has the following six wires, hooked as follows: Orange to O Green to G Yellow to Y1 Red to R Black to C White to W1 I am attempting to install the Hunter Programmable thermostat, which only gives me 5 placements for wires:

View more questions Search