Ask Experts Questions for FREE Help !
Ask
    mikeco's Avatar
    mikeco Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 26, 2008, 12:04 PM
    1990 honda civic
    I have a 1990 honda civic does not fire has new distributer
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Jul 26, 2008, 12:22 PM
    . Test all under-dash and under-hood fuses with a test light or multimeter:

    https://www.askmehelpdesk.com/cars-t...tml#post252145

    . Does the Check Engine Light come on for 2 seconds and then go out, when the ignition switch is turned to ON (Position II)?

    Many on this site have had problems with new aftermarket distributors not working properly. I only recommend genuine Honda distributor housings, where it's okay to install an aftermarket ignitor and coil.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1990 Honda Civic cx [ 2 Answers ]

Help! My brakes just failed! The whole brake system was recently replaced. When the car is off, the brakes feel solid. As soon as I turn on the ignition, there are no brakes. It is an automatic transmission. When the car is on and I push on the brakes, there is a clicking sound from under the park,...

1990 Honda Civic won't run. [ 6 Answers ]

My 1990 Civic died while I was driving it. It has spark at the plugs, it's getting fuel to the throttle body (dual point fuel injection), the timing belt looks like new, the motor has good compression and turns over good but it won't even try to start. I replaced the ecu with one I know is good....

1990 honda civic dx [ 1 Answers ]

I can get in my car in the morning and it starts right up and runs great. Go somewhere park it and a couple hours later get in it to go somewhere and it won't start. After a couple of tries it will start. It happens when it is sitting in the heat. What could be the problem?

1990 Honda Civic LX 1.5L [ 1 Answers ]

I am getting an error code 8 (TDC Position) and an error code 20 (Electric Load) on my ECM. I cannot find any detailed information about either of these codes. Can anyone help me either locate a site that has good explinations, or advise me on what I should be looking at. The problem that I...

View more questions Search