Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Inline fuse holder?
[ 2 Answers ]
When adding an inline fuse holder on transfomer it goes on the red wire on secondary side, right?
Wiring inline duct fan to furnace fan goodman gmp100-4
[ 2 Answers ]
How do I wire my inline duct fan to my Goodman model gmp100-4 gas furnace fan so that the inline duct fan comes on and off when the furnace fan does? I understand that I need a relay from the inline duct fan but don't know where to connect the relay to the furnace.
Inline vs AAV
[ 6 Answers ]
Different question same bathroom... I'm adding a washer hookup in a 2nd floor bathroom. Due to space and framing restrictions I'm not tying in to the stack on the second floor but have run 1 1/2 pvc drain down the outside wall to the basement, and joined the (vented) kitchen sink drain line...
Flexi Duct vrs Aluminum Duct
[ 4 Answers ]
I am adding an addition onto my house. The local building inspector has already told me my HVAC unit is more than adequate in size to support the addition. The old duct vents are aluminum. Can or should I use flexi venting in the new part? What are the pros and cons of these two types of vent...
Inline inducer
[ 3 Answers ]
The room over my garage is the furthest room my furnace. It is colder in the winter and hotter I the summer than the res of the house. I am thinking of buying an inducer to boost air flow. Should I install the one with the heater as well? What happens in the summer with air conditioning? Where is... View more questions Search
|