 |
|
|
 |
New Member
|
|
Jul 13, 2008, 10:01 PM
|
|
toilet leaks at base?
Unfortunately I have carpeting in my bathroom, which will probably come up tomorrow, BUT my problem is that for some reason, the rug is soaking wet in front of the toilet. About 4 inches in front of the base, the rug is wet roughly 2.5 feet x .5 feet. Is it possible that the wax ring is leaking, or maybe it is something else? I'm not familiar with toilets on the ground level, but I know the rug isn't supposed to be wet. The rug is not wet on the sides or back. The toilet is about 18 years old, the flooring of the house even older.
|
|
 |
Full Member
|
|
Jul 13, 2008, 10:21 PM
|
|
Might be your wax ring. About $5.00 and 1-2 hours labor, if that, and you've solved the problem. BTW, if you are still up, 24 hour department/supermarket/mega chain stores sell them in the hardware aisle. You could do it tonight.
|
|
 |
Full Member
|
|
Jul 13, 2008, 10:22 PM
|
|
I forgot. Shut off water supply to toilet until repaired, flush toilet to empty bowl, and don't use until fixed. That'll slow the leak down.
|
|
 |
Ultra Member
|
|
Jul 13, 2008, 10:34 PM
|
|
MaMablues57 - It could very well be the wax ring leaking go to Lowe's <HOME DERPOT OR Plumbing supple and get you a new set of anchor bolts for a toilet , the old ones will already been cut off and you won't be able to get fitted you won't seperaye as easty to
Nuts back on also get a flange on I t And install irt correctl
|
|
 |
New Member
|
|
Jul 14, 2008, 01:39 PM
|
|
Thank you for your advice. After realizing this means taking the toilet off the ground, I am going to have to call in a plumber. My husband recently had rotor cuff problems in his shoulder, and cannot do the heavy lifting required at this time. I appreciate your help and advice. Thanks, and God Bless.
|
|
 |
Full Member
|
|
Jul 14, 2008, 03:54 PM
|
|
You might not have to lift the toilet, per se. Can he push it to the side enough to do the repair? Remove all the bolts, use WD-40 if need be, and to get the bolts off, and then nudge it, while holding on to it to keep it from falling over. Take the old ring off, throw it in the bag that the new one came in and tie it up and throw away. Take new ring and place it over pipe, and nudge the toilet back. The toilet itself will leave a mark on the concrete, so you'll have a guide for replacing it in the right spot. Then re assemble all boltage, and turn water on slowly to check for further leakage. It should then be replaced.
But Come to think of it, rotator cuff problems are very painful, so a plumber, or... a handyman which would be cheaper, could do the job for you.
|
|
 |
New Member
|
|
Jul 14, 2008, 05:26 PM
|
|
Thanks, but the floors aren't concrete - they are wood. This house was built in 1935. Isn't even a slab under it. Also, very tight space - maybe 8" on each side. Bathtub on one side, cabinet for sink on other. I'm going to call the local lumber yard tomorrow and see if they know someone locally. Otherwise I'm going to be paying a trip charge for someone to come out. I live just outside the 20 mile free no-charge zone (naturally). Oh well - you know what they say - **it happens. :)
|
|
 |
Full Member
|
|
Jul 14, 2008, 05:42 PM
|
|
Oh well - you know what they say - **it happens. :)
And in your case, maybe literally...
Ask that lumber yard if there is a handyman that can help, because the actual repair isn't hard. But you have to be strong like an ox. And have the same inspect the wood. You don't want to to have damaged wood underneath a heavy object in a delicate situation...
The reason I keep harping handymen, is that I have been charged by the plumber. And when I found out how simple the repair was (and it wasn't the wax ring, that's a different story), and how much they cost, I about fainted. Now for simple stuff I get a handyman, and pay a third of what I would have been charged. Hopefully you'll be up and running soon!
|
|
 |
Plumbing Expert
|
|
Jul 14, 2008, 06:38 PM
|
|
Your angle stop may be dripping. Also your toilet supply or perhaps you have drip for the tank.
But first, check wax ring...
|
|
 |
Ultra Member
|
|
Jul 23, 2008, 09:23 PM
|
|
Mamablue57 - Please don't do it the way " BigBopper" said to :: REASON - If you do ,You will ruin the new wax ring and there will be wax left on the flange which some of it will be hardened and ( I Guarantee you that you will have a water leak out of this world, and will have to do it all over again . Sincer youal won't be able to lift , and don't have any one that you can have to help , Then I susgest that you do call a plumber, Good Luck AND GOD BLESS. Let us all know how you come out ::: F.B.E.
|
|
 |
New Member
|
|
Jul 23, 2008, 09:55 PM
|
|
Thank you for your advice. All repairs have been temporarily put on hold. My fuel pump on my car went out, and that came first. I'll just have to be very careful for a few weeks until we get back on our feet financially.
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
New toilet leaks around base
[ 3 Answers ]
I just finished replacing the floor in a bathroom with tile (previously was vinyl). I added a flange extension to the toilet flange to raise it due to the higher floor height of the tile.\
I have set a brand new toilet twice now and both time it has leaked around the base. When I pull the...
Toilet leaks at handle
[ 5 Answers ]
I have the same problem as this guy:
https://www.askmehelpdesk.com/plumbing/toilet-leaks-handle-14062.html
Can anyone care to help an extreme novice at fixing this?
Toilet water inlet leaks
[ 4 Answers ]
The 18" brass tubing on the water inlet has a crack right at the angle stop. Big crack, big leak when the valve is open (no leak when the valve is closed). Can this tube be replaced without solder/welding? This home was built 14 years ago (fixture age). I've heard speedball say there should be...
Toilet leaks
[ 7 Answers ]
Hello. My tenant just phoned to say that the handle of the flush leaks when it is flushed. She also is noticing water around the base of the toilet. Just checking in to see what I should look for when I go over and what some possible solutions might be?
Many thanks,
JD
Toilet leaks at handle
[ 9 Answers ]
Help, the tank fills up too much, all the way to the handle! And then starts drip drip dripping outside the handle connection into a bucket! But I notice that when the toilet is used a lot (flushed) it does not doing it as often, I guess because it takes a while for the tank to fill up to the top...
View more questions
Search
|