[brenda99]

This washing machine is 8 years old and all of a sudden today the spin cycle stopped working... The timer and switch both are working... we think it's the clutch?? Any suggestions?

I need to know if this is a costly repair or if I should consider purchasing a new washer?

Thanks for any help or recommendations you may be able to provide.

Brenda

[Credendovidis]

Hello Brenda

You have to do a little research here, to check what is going on in your machine :

Older model washing machines have often a motor that actually consists of two different motors into one, one for washing and one for spinning. Each motor has it's own start capacitor.
With newer models with electronic speed controllers spinning may be arranged either the same way, or via an electronic board.

In your specific case with an older model there are two possible causes for the spinning problem :

1 - The spinning motor itself is faulty. This actually seldom happens.
2 - The start capacitor is faulty.This is a frequent problem.

The real problem is to find the start capacitor, as there are two of them : one for washing, and one for spinning.
Start with removing the power : take the power cable out of the socket and put it on to the ground.

Find the two capacitors : they look very similar : an oval or round metal container with two or three connection points. Often with stick-on connections.
Now disconnect one wire from one capacitor.
Reconnect the power, and see if the washing cycle still functions (empty drum).

If NOT so : this is the washing motor capacitor. Remove the power : take the power cable out of the socket and put it on to the ground.
Careful : there still can be power on the capacitor, so do not touch both contacts.
Reconnect the wire you took off. Disconnect the other capacitor, and bring it to a service shop for washing machines to have it tested and - if needed - to be replaced.

If so : this is the spinning motor capacitor. Remove the power : take the power cable out of the socket and put it on to the ground.
Careful : there still can be power on the capacitor, so do not touch both contacts.
Disconnect the second wire also and remove the capacitor. Bring it to a service shop for washing machines to have it tested and - if needed - to be replaced.

If you have a multi meter you can also measure the capacitor for leaking. Let me know if you want to do that, and I'll advice you what to do / how to do that.

Of course you can also come back to the board, discuss your findings and ask for advice !

Success !

:)