[jancyg]

First it started taking many pushes of the handle to flush now won't flush at all

[KISS]

Have you tried using a plunger or closet snake?

Image:Plunger 250x410.jpg - Wikimedia Commons

There are specific instructions for each and there are plungers made specifically for toilets.

How to Use a Toilet Plunger

[speedball1]

first it started taking many pushes of the handle to flush now won't flush at all

I have one that most repair plumbers miss.. Look down at the bottom of the bowl. If there is a small hole, then that is a jet that starts the syphon action. If it's clogged the water will just swirl around and slowly go down leaving solids behind. Take your finger,(UGH! ) and run it around the inside of the opening. Over the years minerals build up and cut down on the syphon (flush) action. If it is rough or you feel build up, take a table knife and put a bend in it to get around the curve in the bowl and chip and scrap it clear. Next take a coathanger and clear out the holes around the rim. They start the swirling action. And last, check the water level in the tank. It should be 1/2" below the top of the over flow tube. And speaking of the overflow tube, Make sure the small 1/8" tube from the ballcock to the white overflow tube is connected so it discharges in it and that it's flowing when the ballcock fills. This is what raises the water level in the bowl. For a good solid flush they all have to work together. Hope this helps but if it doesn'tclick on back, I have more solutions. Tom