Ask Experts Questions for FREE Help !
Ask
    N2TECHNO's Avatar
    N2TECHNO Posts: 39, Reputation: 2
    Junior Member
     
    #1

    May 31, 2008, 08:00 AM
    A/C Condenser or Switch?
    I think maybe the condesor motor is going bad, while a/c is on sometimes it spins for just a few seconds and shuts back off if I tap the top of the shroud it stays on, Sometimes it jerks all over trying to kick in? A/C is blowing hot air, and when motor is working it will blow cold. Yesterday in 90+ weather it blew really hot. Is it a switch or a/c condenser motor? I only have enough money to fix one part at this time. Thanks.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    May 31, 2008, 08:17 AM
    Disconnect the negative battery cable and clean the condenser fan motor connector. Disconnect the condenser fan relay and try jumping the condenser fan motor. This should tell you if the fan motor is bad or not. If the problem persists, check the condenser fan relay.
    N2TECHNO's Avatar
    N2TECHNO Posts: 39, Reputation: 2
    Junior Member
     
    #3

    May 31, 2008, 08:18 AM
    If only I knew how to jump it, I am no longer at my friends shop.
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #4

    May 31, 2008, 08:32 AM
    Disconnect the battery cables, so as not to short out anything else on the car, separate the condenser fan motor connector, and run two jumper wires from the battery to the condenser fan motor connector.
    N2TECHNO's Avatar
    N2TECHNO Posts: 39, Reputation: 2
    Junior Member
     
    #5

    May 31, 2008, 08:54 AM
    I disconnected it and ran the a/c plugged it back in and the fan started, I think I had to hit the top of fan to get it to work.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Condenser wiring [ 5 Answers ]

Hi, I am installing wiring for a new central air condenser that is being installed next week, and I wanted to make sure I was not missing anything. The HVAC installer told me that I needed #8 and 40 amps. I have a flexible whip to go from the disconnect to the condenser and have run (2) #8 wires...

Condenser wiring [ 1 Answers ]

What type/size wiring for 3.5 ton condenser?

Condenser Fan Wiring [ 2 Answers ]

I Purchased A New Condenser Fan. The Old Fan Had Three Wires One To The Contactor(black) Then Yellow Wire To The Capacitor And Brown Wire To Capacitor. The New Motor Has Four Wires Brown , Brown With White Strip, Black And Purple. The Fan Diagram Shows You Can Connect With Only Three Wires. It...

Condenser Fan won't stay on [ 14 Answers ]

My A/C system is 17 years old and for the first time the condenser fan stopped working. So I thought it would be the motor so I replaced both the motor and the capacitor at the same specifications. Turns out I'm still having the same problem. The fan will start when I first turn everything on...

Condenser wiring [ 2 Answers ]

Hi, I am installing wiring for a new central air condenser that is being installed next week, and I wanted to make sure I was not missing anything. The HVAC installer told me that I needed #8 and 40 amps. I have a flexible whip to go from the disconnect to the condenser and have run (2) #8 wires...


View more questions Search