 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
You need to replace the rubber spark plug seals in the valve cover. They prevent oil splashing around under the valve cover from getting into the spark plug tubes. When you have the valve cover off, it would be good to replace the rubber valve cover seal, too.
Cylinder head cover bolts are torqued to 7 lb-ft. Carefully apply oil with your finger to the bottom of the 4 rubber spark plug tube seals, when installing the cylinder head cover. Easy job. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
For the past couple weeks every time I would be stopped at a stop sign/light, my car would rev itself a little and jerk. It wasn't hard but enough to definitely notice. Yesterday while driving, I heard a terrible sputtering sound and pulled over to discover that one of my spark plugs had blown...
My girlfriend bought a honda 3011 mower that won't fire. I think the plug may be fouled. Does anyone know the model from the factory? I want to try and see if that works.
1995 Honda Civic was starting and running fine. I changed spark plugs, but inadvertently left one plug wire unhooked on top of engine. I started the car. It ran for a few seconds then shut down. Now it won't start again. It cranks, but won't start. I've checked fuses, but all are okay. Did I...
I have 94 accord with 185K. I am changing the plugs and have oil in #2 and 3 spark plug holes. Should there have been orings or gaskets changed during a recent Timing belt change I had done at the dealer? Timing belt change was doen within the last 10000 miles
I recently installed Autolite spark plugs into a 2003 Honda accord. After installing, car began to randomly misfire. After driving car 35 miles, car blew 3 back side piston rings and catalyst converters. My $10 plugs are costing me $8700. Would the Autolite plugs be too hot or simply a...
View more questions Search
|
