Ask Experts Questions for FREE Help !
Ask
    Lori Ellis's Avatar
    Lori Ellis Posts: 2, Reputation: 1
    New Member
     
    #1

    May 21, 2008, 07:25 AM
    Removal of a Nidel 34HD with knock off theft bolt
    The vacuum breaker on my sillcocks is a Nidel 34 HD with the knock off screw for theft prevention. I need to replace it, but I am unsure how to remove it. I am afraid if I try to forcibly unscrew it, it will damage he sillcock.
    Lori Ellis's Avatar
    Lori Ellis Posts: 2, Reputation: 1
    New Member
     
    #2

    May 24, 2008, 03:42 PM
    Drill out the set screw and then you can easily remove the vacuum breaker.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

What size & type of bolt [ 1 Answers ]

I am trying to remove the starter on my Craftsman mower. It has a B&S 12.5 hp I/C engine about 12 yrs old. I need to replace the cog wheel on top of the starter. My cheapo hex key set will not fit, what size specifically do I need to remove the two bolts holding the starter?

Removal of bolt above Mandrel pulley on Craftsman tractor [ 1 Answers ]

I am having trouble removing the bolt from the top of the mandrel pulley on a Craftsman lawn tractor model number 917.271051. Does it have to be removed in a certain manner?

05 Impala caliper bolt [ 5 Answers ]

I'm replacing the rear brakes on my 05 Impala, and I have messed up bad. I took of the rotors to have them refaced, but when I went to put them back on, it seems that my caliper pins are 2 different types. One is smooth with the threads on the end, the other has a small rubber seal at the end of...

Rocker Arm Bolt Stripped [ 1 Answers ]

I have a B&S 14.5 OHV and the rocker arm bolt is stripped. Does anyone know what size the thread are that go into the cylinder head? I am hopefully going to try and match a helicoil and retap the threads. Dang aluminum! Thanks in advance! If you have any other suggestion I could try, it would also...

Foundation j bolt retrofit [ 4 Answers ]

House has never had any tie down j bolts on The mud sill. However concrete blocks are hollow and usually They fill down two blocks with mortar and place the J bolt in the wet mortar poking up through holes You bore in the mud sill. Can I cut out the face of the block on one web, Put the j...


View more questions Search