 |
|
|
 |
New Member
|
|
May 10, 2008, 04:03 PM
|
|
Need to access basement floor drain to auger it
After removing the drain cover, I discovered a white cap screwed into the side of an apparent insert of some type, After removing the white cap, do I need to remove this (insert?) in order to use EEL to unclog this sewer drain? If so, then how?
|
|
 |
Eternal Plumber
|
|
May 11, 2008, 06:28 AM
|
|
 Originally Posted by Siouxsiecue
After removing the drain cover, I discovered a white cap screwed into the side of an apparent insert of some type, After removing the white cap, do I need to remove this (insert?) in order to use EEL to unclog this sewer drain? If so, then how?
This white cap is the floor drain clean out, (see image) this bypases the trap and gives your snake a straight shot at the clog. Remove the insert and send your snake down the opening. Good luck, Tom
|
|
 |
New Member
|
|
May 11, 2008, 11:07 AM
|
|
Speedball, we rented a 4" auger, as suggested by the rental folks, it does not seem to fit through the opening after removing white cap, would the 2" auger have been a better idea?
|
|
 |
Eternal Plumber
|
|
May 11, 2008, 11:25 AM
|
|
They suggested a 4" auger for a 1 1/2 " cleanout opening on a floor drain? Go back and tell them you wish to rent a Ridged K-30 sink machine, or equivalent, with a small auger tip. Or you could purchase a hand held power snake,(see image) and have the tool handy for the next clog.
|
|
 |
New Member
|
|
May 11, 2008, 12:13 PM
|
|
S.B.
I'm sorry to keep bothering you, I told them it was a floor drain to the sewage (which it is) it occasionally gets roots into the line and that's why it clogs, we have had plumbers out in the past and they used "something" like what I rented. I don't believe a "snake" would be strong enough to break up these roots, am I wrong?
|
|
 |
Eternal Plumber
|
|
May 11, 2008, 01:33 PM
|
|
I don't believe a "snake" would be strong enough to break up these roots, am I wrong?
You shouldn't be bothered with roots in a floor drain. But if you have roots a snake will auger into it and pull them back. You're not going to get a cutter tip through the floor drain clean out. Use the auger to clear the line and if roots are a problem then let's control them. For immediate relief and to kill the existing roots and prevent further growth you can purchase RootX or Robics Foaming Root Killer that contain Dichlobrnic.
A less expensive way would be to call around to garden supply stores and ask for fine grain Copper Sulphate. Put a 1/2 pound in your toilet and flush it down. Repeat in 6 months. Good luck, tom
|
|
Question Tools |
Search this Question |
|
|
Add your answer here.
Check out some similar questions!
Basement floor drain
[ 8 Answers ]
Hi, I am having trouble with my basement floor drain running slow and am looking for some advice. I have to assume that the current configuration is a poor design and am willing to redo whatever is necessary to get it right. Currently, the floor drain is a 4" cast iron drain. There is a 1 1/2"...
Basement floor drain
[ 1 Answers ]
We were having problems with the basement floor drain not draining, so a friend (who worked for Roto Rooter) came over and unplugged the "overflow plug" and said that would fix it.
Another friend at a later date said that was dangerous because of methane gas coming up - can you tell me who is...
Basement Floor Drain
[ 2 Answers ]
I have a floor drain in the basement which appears to be dried out. When I put water down the drain it just sat there for a couple of days before drying out. Could the drain have a blockage and, if so, how do I fix it. I'm concerned because the drain is the only apparent relief from water in the...
Basement floor drain
[ 1 Answers ]
My basement floor has no floor drain. I am concerned that if there is a water event like a hot water heater rupture the basement will flood. What is the best way to install a floor drain for the basement? I have busted up some of the slab because I am adding a bathroom in the basement. Have you...
View more questions
Search
|