Ask Experts Questions for FREE Help !
Ask
    xkimmy72x's Avatar
    xkimmy72x Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 8, 2008, 01:41 AM
    Car won't fire up
    I am having problems starting my peugeot 106, it turns over but won't fire up. I have had a new crankshaft sensor, coil pack and ignition switch, can anyone help please..
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    May 8, 2008, 06:05 AM
    . Check for spark. Since it sounds like you have no spark, check "key sensor" reference voltages. If they are way low, the ECM is likely bad. I like what you have focused on so far--the ECM is the next step in the progression.

    . Check for fuel.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Shower won't fire boiler [ 2 Answers ]

I have a Worcester 35 CDi boiler. Recently the shower in the ensuite and the shower in the bathroom won't fire the boiler when turned on. If the heating is on, the showers work but not on their own. The hot water in each sink and the bath works and if you take the head of the showers, the water...

95 civic won't fire [ 1 Answers ]

My 95 civic won't start I'm getting fuel, spark, but it just keeps turning over but doesn't fire. It crunk up and ran for a little bit the other day and thought I had it fixed but went out the othe rday and it doesn't do any thing but just turn over any suggestions

Main gas won't fire [ 1 Answers ]

Heil 7000 High Eff Purge blower turns on Pilot fires, main gas will not open / fire or rather honeywell (VR82041075) MV won't open. Electronic board MV output voltage is what to valve? No manual. Module HQ1005962EX

Briggs 18hp won't fire [ 7 Answers ]

Have an 18hp Briggs Twin that quit and would not start. After detecting a weak spark, replaced plugs and coil. Ran great for two weeks, now week spark again on new coil. Only get strong spark when one coil wire is grounded. Then the other gives strong spark. Could the starter be turning too...

Troy Bilt won't Fire [ 4 Answers ]

Troy Bilt Model #3AQ609G063, 18hp B/S engine Twin II (model # for engine is42A707). I replaced the starter,solenoid, and it has a new battery. When I turn the key nothing. I jump the solenoid and the starter turns. I jump the starter and it turns. There is plenty of gas getting to the carb but, no...

View more questions Search