Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Framing tile shower stall
[ 1 Answers ]
I am re-framing a shower stall in which I will not be using a pre-fab shower. The stall itself was a 34 x 51 stall. What I am concerned about is the shower door that we will be using. It is 22 1/4" wide. How do I frame the facing wall? I will not be using a pre-fab shower pan either so I need to...
Replacing Leaking Shower Stall Concrete Base
[ 8 Answers ]
In my basement I have an old shower stall that was installed by the former owner. The stall also has the air conditioner drainage hose directed through the bottom of shower stall and it drains into the shower drain. That is not my idea of sanitary! Also, there is no top (cover) over the stall. ...
Tile shower base
[ 5 Answers ]
Hello All, I'm redoing my basement shower. I'm planning on tiling the base and the two corner walls. My main concerns are with the base. 1. The floor is slightly uneven where I'll be framing the base. Can I just use a self leveling compound in this area? 2. Do I use 2 x 10 sections in...
Sealing shower stall base
[ 1 Answers ]
There is a leak between the acrilic wall and the shower stall pan. Caulking using acrilic did not help. Shall I cut the plastic wall and/or use some special sealing material? Thanks!
Shower stall base
[ 3 Answers ]
I purchased a house with an unfinished half bath. The shower base was not installed. There is a cast iron pipe coming up through the slab.there is a drain leaded into the pipe with a flange and a liner that is cut off,and a threaded 2" drain screwed into it,it has been there a long time and I... View more questions Search
|