Ask Experts Questions for FREE Help !
Ask
    reedlr's Avatar
    reedlr Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 19, 2008, 07:26 AM
    York furnace model #p1ddb12n08001c
    I replaced my gas valve because it was cutting off after a few minutes of operation. This worked great for about a month or so but now it is doing the same thing again. Is there another issue or is the gas new gas valve bad too?

    Any help will be appreciated.

    Thanks

    Reedlr
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Apr 19, 2008, 11:55 AM
    You may have a limit switch opening killing 24 volts going to the gas. Check your return air filters to make sure your moving good air through the furnace. Restricted air flow will take you out every time.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York Stellar Furnace Heating up Furnace Room to 110 Degress? [ 2 Answers ]

I have a York Stellar Furnace in my newly purchased house. Furnace is 15 years old. Furnace is releasing hot air from front grills and heats up furnace room to 110 Degrees. I had a Bryant Furnace in another house and this never happened. All plenams and ducts are taped and sealed so the heat is...

York Model P1CK, ignites then locks out after 5 cycles [ 1 Answers ]

Hello, I have a York P1CK D1N06401A natural gas furnace in an upflow orientation. The equipment is 11 years old and has all original parts and controllers. The LED fault code is 8 flashes which, according to the Installation documentation ("Indicates that the flame has been lost 5 times during...

Replacing an old Honeywell Thermostat with a Hunter Model 44260 to a York Heat Pump [ 0 Answers ]

I have an older Honeywell thermostat with wiring G(green) W(white) R(red) X(blue) B(black) O(orange) & Y(yellow). My new programmable thermostat Hunter 44260 has G R/C R/H Y/O W/B & Y1. Which wires go where on the new 44260 thermostat? The manual is not easy to understand. Thanks! D

York furnace not responding [ 6 Answers ]

Hi. I apologize in advance for the long post. I have a 10 year old York gas furnace (Model P1CK; Upflow; 32-112 MBH Output) that's been functioning in a peculiar way. The outside temp in this area has been about 65-70 daytime high and 35-45 at night. I have the thermostat set for 66 degrees...

York furnace [ 1 Answers ]

Furnace works fine then turns off when house warms up to temp. will not come back on until I turn furnace off and on . Code flashes one time saying system lock out. What should I do ? Thanks mario

View more questions Search