 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Wires from briggs engine don't match
Swapinng engine .Two 2 pin conectors one conector red and black wire one connector two black wires. New engine has 6 pin connector from engiine there is red from altenator gray from carb anti back fire where do the black wire and blue wire conect to?:rolleyes:
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Hi there! I just intalled a harbor breeze ceiling fan, and followed the wiring instructions specific to having both the fan and the lights controlled by switches, as opposed to a chain. I then purchased a "Cooper 4 Speed Fan/Light Dual Control" switch and am stuck with two questions that I...
Hi there We were lucky enough to get a Lowe's gift card for christmas so today we went and bought a programmable thermostat. Our old one is from when the house was first built I think (so at least 20 years old).. new one is a Hunter 44550 old thermostat seems to be no name brand.. ...
Sir or ma'am- I am attempting to replace my 1960's era Honeywell thermostat with a modern 5-1-1 and I managed to thoroughly confuse myself. My 1930's era house only has gas heated radiator system connected to this thermostat. We added central air 6 months ago but it is on a separate system. ...
Yesterday I installed a new Hunter ceiling fan. I also purchased a Hampton Bay wireless wall switch. Everything went well until I wired up the remote receiver. The receiver has a blue wire for the light that is supposed to connect to the blue wire (light) from the fan. The Hunter fan does not have...
View more questions Search
|
