 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Kenmore Series 80 gas dryer runs but forever to dry
Hi - I have a 2003 Kenmore series 80 dryer that runs and seems to get warm but won't dry any significant load without 2-4 cycles. The element has been checked by a and seems to work. Tips on where to start? I've read up on this site but am cautious about pulling it out and getting started without a schematic to finish the project. Thanks!
|
||||
|
||||
|
Before taking it apart, I'd make sure the vent pipe is not clogged with lint. This could cause the problem you have.
You say it is a gas dryer, and the element was checked, which confuses me:confused: . If it is electric, I'd make sure you have 220v at the plug. Good Luck, WallyH |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a kenmore gas dryer, that up until this point I have had no problems with-i dried a load of towels yesterday and then later that day the dryer was turning the clothes but there was no heat!--where do I look first?
Has gas but no heat, any suggestions?
The hot surface igniter glows lights the first time then runs for about 3 minutes then glows again in about 2 minutes shuts off with out lighting the burner, cleaned the vent out any ideas?thanks hixton
It's not heating up. It tumbles. I already checked the vent and air is flowing. Also, ckecked the thermal-fuse and thermostat and their continuity is Zero. Also, the igniter looks in one piece. And turned the breaker on and off. What could the problem be?
I have a kenmore dryer that is 10 years old. The dryer heats up, but the clothes take at least 4 times longer than what they should. I have noticed that when I open the dryer there is hot moist air inside the dryer and the clothes have a kind of mildew smell. My lint filter is clean, the back of...
View more questions Search
|
