Ask Experts Questions for FREE Help !
Ask
    malarab's Avatar
    malarab Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 20, 2008, 10:24 AM
    Furnace doesn't comes on till I turn switch off then on
    My furnace doesn't comes on till I turn switch off then on
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Feb 20, 2008, 10:55 AM
    You are resetting the furnace. Next time it is off see if there are lights blinking on the circuit board. If so there is a legend on the wiring diagram on the blower door.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Light on 3-Way Switch Won't Turn Off (Change Switches Already) [ 4 Answers ]

To summarize, I have a light on a 3 way switch that will not go off via the switches. I replaced both switches with new 3 way switches and the light still won't go off. We have a hall light that has one switch upstairs and one switch downstairs. The light won't go off so I changed the switches...

Engine run on after switch turn off [ 5 Answers ]

I have a 98 Mitsubishi Montero and the engine continues to turn over after the ignition is turned off. Turning the key off does cut off fuel because you can hear the difference and turning the key back on does bring the engine back up to full idle. The only way I could shut it down was to...

Adjusted Limit Switch Now Blower won't Turn On [ 1 Answers ]

I turned on the furnace for the first time last week and the blower woudn't turn off. I did some research on this site and upon investigation the limit tab setting was set at 150 and the "on" was all the way up to the limit tab at 150 as well. The "off" was set at 50 and I think that's why the...

NG Furnace will not turn on [ 2 Answers ]

Make: RHEEM Model: RGDO 06NC ER Installed: 1990 Problem: Observe glow in burner area from ignitor but the gas won't turn on. After a few seconds the glow will turn off. The Hot Surface Ignition Module was replaced in 1997. Please advise.

View more questions Search