 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Flame cycling!
I have a Temstar NUGK100DH08 gas HVAC. The unit lights then flame dies down, re-ignights and continues this. Temperature set at 72*. Flame doesn't appear to be rolling out. Exhaust motor is running O.K. and no vacume leak.
Does anyone know what's wrong. Thks Mike! |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My newer energy efficient furnace cycles every 10 minutes about, I have a new one story home that is very well insulated.
I have a comfortMaker RDPJII mfg date 92. It will not stay lite after the blower comess on it shut off and start over again
I have a Trane gas furnace w/no standing pilot it's electronic. Anyway when the t-stat calls for heat it will fire up and the shut of within 5 secs. It will do this approx. 4 times before it will eventually lock itself out and the blower will continue to run not ever reaching setpoint. I know...
Thermostat calls for heat, ignitor comes on, burner lights, when hot enough for the fan to come on the burner shuts off. The fan runs for awhile and the ignitor comes back on, lights the burner, runs for a short time and everything shuts off. Then the cycle starts all over again but does not reach...
My fan and gas shuts off after only a few minutes in the heating cycle and restarts again shortly, only to shut off again... and so on. I think it's the fan limit switch but don't know if I should replace it or try adjusting the limit. Any advice??
View more questions Search
|
