Ask Experts Questions for FREE Help !
Ask
    cfservices's Avatar
    cfservices Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 30, 2008, 07:48 AM
    Aquaflow 1/4 turn angle stops
    I installed 1/4 turn tops on sinks. The inspector says I need to remove the 1/4 turn stops and install Aquaflow 1/4 turn angle stops. What is the difference? Is Aquaflow a brand name? Are there manhfacturers?
    iamgrowler's Avatar
    iamgrowler Posts: 1,421, Reputation: 110
    Ultra Member
    		  
    #2

    Jan 30, 2008, 07:57 AM
    Aquaflow is a brand name.

    I'm not sure why your inspector requires a specific manufacturer, but around here we buy them at Consolidated Supply.

    Call around to a few of your local Plumbing supply houses to see which one carries the required stops.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Lennox heat turn off and turn back on to work [ 2 Answers ]

I have a lennox heater I have to turn it off and turn it back on to get it to heat. What is wrong and how do I fix it.

Well water system: shower stops whole house water stops and starts [ 2 Answers ]

I have a plumbing/well water question. Recently our water flow has been stopping (during a shower or in the sink). The entire house water supply stops. Sometimes there is a noise - like air - as if we've been away for a month. Sometimes there is no noise at all, the flow goes down to a trickle...

Angle Stops Problems? [ 1 Answers ]

I have a bathroom sink that has no water, only a drip coming from it. It's a standard 2 handle faucet. While reading other questions, it occurred to me that my problem may be the angle stops being clogged. If this is the case, can I unscrew the valve at the point where the red arrow is in the...

Frozen angle stops [ 1 Answers ]

I can't shut the water off under my bathroom sink. Is their a way to free them up without replacing them?

Projectile - what angle? [ 15 Answers ]

Hello All, I have a question on projectiles, but I am unsure what formula I need to use to calculate the required angle. A projectile leaves the nozzle at 14 m/s, at what angle should the nozzle be so that it hits the nearest edge at the top of a wall 0.7m high with a horizontal distance oy...

View more questions Search