Pilot light

thomas1974 Posts: 1, Reputation: 1

New Member

Jan 23, 2008, 09:40 AM

Pilot light

The pilot light on the gas heater keeps going off

hvac1000 Posts: 14,540, Reputation: 435

Heating & Air Conditioning Expert

Jan 23, 2008, 09:56 AM

Thermocouple replace.
Clean pilot orifice

Add your answer here.

Check out some similar questions!

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

Pilot light stays on but pilot switch keeps resetting [ 5 Answers ]

I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...

Pilot light on propane furnace won't light [ 7 Answers ]

Hi! This is a little long, please bear with me... Two days ago we woke up to a very cold house, and upon investigation found that the pilot light on the furnace had gone out. Searched around, didn't smell much gas - so we tried to re-light it. Well, it lit and stayed lit (and we got the...

Cannot light Pilot Light on Water Heater [ 2 Answers ]

My water heater is located in my attic. After Katrina, I had to repair my damaged roof and it seems that the attic fan went out. Since then my water heater pilot light has repeatedly gone out. I can re-light it usually, but the lack of air up in the attic causes the light to go out. Presently,...

Another pilot light won't light (gas wall heater) [ 1 Answers ]

I have the same problem as the person who asked about getting their wall heater to light. The answer was to make sure the flame was touching the thermocouple.. . But how do you do that? I can't make the flame higher, so do I move the thermocouple lower and what does a thermocouple look like...