Ask Experts Questions for FREE Help !
Ask
    wjmesmatl's Avatar
    wjmesmatl Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 21, 2008, 09:12 PM
    Coleman Blendair
    I replaced the fan motor and housing unit for my blendair with a new roof unit. The moment the 110 electrical connection was completed, the fan came on. I went to the heater and pushed the two buttons down to set the system as it was. The red light was flashing and the alarm begin within about 3 seconds. The fan want turn off unless I trip the breaker in the panel box. The prior fan motor on the roof burned out. What must I do to get the system to set properly and the alarm and red light to stop?
    Thanks in advance for any help.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 21, 2008, 09:59 PM
    Go here and place question under Coleman

    mobilehomerepair.com :: Index

    They also have the parts.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Coleman Furnace [ 8 Answers ]

I Have a problem on a Coleman furnace, model # DGAA070BDTA. The problem is when the furnace kicks on, it lights the hot surface ignitor and lights the burner, but as soon as the fan comes on the burner shuts down and cycles about 5 times then shuts down. I have changed the board 2 times, replaced...

Coleman Evcon BlendAir Alarm [ 3 Answers ]

I have an ~ 1998 Coleman Evcon gas furnace in a mobile home. It has a "BlendAire II" system on it. Recently, an alarm went off which indicates a problem with the vent attic fan. Does anyone know what this does or what typically goes wrong with this ? From what I have read, there is a circuit...

Coleman furnace [ 1 Answers ]

Does the upper limit switch act as a breaker? Will the red button pop up only when it needs to be reset? In other words, if the red button is not popped up does that mean it is working correctly?

Coleman Furnace [ 1 Answers ]

I have a Coleman Furnace in my mobil home and it keeps shutting off and won't hold a temperature. I have had a furnace company out and they replaced a gas valve but it did not help. To get the furnace to start back up I have to turn the thermostat off and then back on. It will run for a while the I...

Coleman Furnace [ 2 Answers ]

Our furnace is kicking on and off. Then it'll kick, but not go further to turn on the blower and heat? Do you think control issue or booster assembly>

View more questions Search