Ask Experts Questions for FREE Help !
Ask
    t2engr's Avatar
    t2engr Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 13, 2008, 06:23 PM
    Bathtub valves
    I am looking for a company that sales a rough in valve with 9" on center not 8" on center? Anyone no any manufacturers of the bathtub valves & faucet that will match this criteria?
    doug238's Avatar
    doug238 Posts: 1,560, Reputation: 62
    Ultra Member
    		  
    #2

    Jan 15, 2008, 07:14 PM
    If it is for a deck mount faucet the majority of 8" rough faucets are expandable. moen would be a good choice because you can solder ridgid copper between them. i personally have only seen 4" and 8" and 12" wall mount tub faucets.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Where are the valves [ 3 Answers ]

Ok... I'll do that... not to sound stupid... but are the valves in the faucet... or somewhere else? Erica

Shut off valves [ 8 Answers ]

This is my problem. I have moved into an older home and I am doing some remodeling and when I went to remove the countertop and sink in the bathroom, I found that plastic piping came through the floor and directly to the faucets. I wish to put a shut off valve on the plastic pipe after shutting...

I think its my valves.. please help... [ 3 Answers ]

Ok I have a 90 accord ex auto and the other day I was driving to pa to visit a friend and I was coming home and I realized while I was pressing on the gas the car was slowing down and I have a pretty loud exhaust and from what I could hear it sounded like a putting sound so I pulled over.. I got...

Studer valves [ 1 Answers ]

I`m doing a plumbing job on new construction. Owner wants to use studer valves instead of through the roof vents for the whole house. I plan to run the vent pipes into the attic And put the studer vents on there. This is a two bath and kitchen and washer box. Will this be OK in Tenn. If...

Zone valves [ 2 Answers ]

Looking for a wiring diagram for a new dunkirk boiler . Just the diagram for the 3 zone valves. Company says that the boiler transformer is enough to run three zones ( 24v) . Or do I need to add transformer. Just can't figure out the wiring from one zone valve to another. Contacts on each zone are...

View more questions Search