Ask Experts Questions for FREE Help !
Ask
    saint cloud st's Avatar
    saint cloud st Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 13, 2008, 05:55 PM
    Cast iron radiator will not heat up
    Hi I have an old heating system(1910) in my home, I have four cast iron radiators three work fine
    But the one in the last level will not heat up. I bleed ed them all but the one on the third
    Level will not bleed. No air pressure comes out of the bleed valve. What should I do.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jan 13, 2008, 08:43 PM
    Check for proper system water pressure. Sounds like you do not have enough system altitude.
    therinnaiguy's Avatar
    therinnaiguy Posts: 153, Reputation: 5
    Junior Member
     
    #3

    Jan 14, 2008, 05:13 AM
    Your boiler should be running at between 12 and 20 psi. Check the gauge. Try increasing the pressure of the system temporarly while bleeding the farthest radiator by lifting on the feed valve lever. Typically this feed valve looks like an upside down ice cream cone with a flat piece of metal like a tail on the top. Lift the tab and you will hear water rush into the system. Get it up to 20 psi and then release the tab. Go and bleed that radiator and see if this helps. If not, you have a restriction in the radiator or a bad circulator. Try this a few times, it may help move the restriction out of the way.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Cast iron plumbing [ 2 Answers ]

I have a 40 year old 1 story rental house built on slab where there are two toilets and one seems to be clogging up very often. I had rescue rooter come out to use a camera. He took the toilet off and stuck his camera down all the way to the sewage manhole. Nothing was broke and there wasn't...

Cast iron to pvc [ 1 Answers ]

Can I switch from cast iron waste, vent pipe to pvc? I just moved to North New Jersey and am not sure of the codes there.

Cast iron problem [ 1 Answers ]

Problem-- mortar, thin set and/ or grout got poured in tub drain on 4th floor and hardened. Can not get material to break free. Went into ceiling on 3rd floor and found 1 1/2" Pipe going to tub with cast iron pipe going into chase. WHAT IS EASIEST WAY TO REMOVE P-TRAP

Cast iron [ 2 Answers ]

Hi folks, What is the best way to repair a leaking tub drain that connects to cast iron main drain? Thank you, Jen

Cast Iron Bathtub [ 1 Answers ]

I have a new cast iron tub to install in an alcove. The tub has feet hidden behind the apron to support the tub. Does anyone have a suggestion as to the easiest way of installation in the alcove?:confused:


View more questions Search