Ask Experts Questions for FREE Help !
Ask
    jimnycricket38's Avatar
    jimnycricket38 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 1, 2008, 10:08 PM
    Rheem LED Light Service Codes
    I have a Rheem AC/ Gas furnace unit, located on the roof, of a rental house. Both the electricity and the natural gas, had been shut off. When both were turned back on, the gas furnace won't work. I took off the service panel, and the led light on the circuit board, flashes 3 times, hesitates, then flashes 3 more times, over and over. Does anybody know what this code could be. Could this be an ignighter code?

    Any help would be appricieted,. Thanks... Jim
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 2, 2008, 12:55 AM
    Usually 3 blinks mean something to do with the pressure switch or the venter end switch. There should be a legend on the door panel of the unit that describes the number of blinks.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman Furnace - Won't Light, No Codes [ 3 Answers ]

Eleven year old Goodman gas furnace. The main vent blower will start, but that's where things end. The draft inducer motor doesn't start and nothing else in the chain obviously happens after that. The LED on the board stays red and never flashes any codes. I checked the voltage coming into...

Service Engine Light Codes for A 2001 Nissan Altima [ 1 Answers ]

I actually have a four part question. 1. What do the codes P0304 Misfire Cylinder 4, P0420 Cat Efficiency Low Bank 1, and P0171 System Tolfan Bank 1 mean? 2. What can cause each of them? 3. What is the best way to fix them? 4. Could the problem have been caused by work done about a...

Service Engine Soon Codes [ 2 Answers ]

I have a 2002 Nissan Altima that is showing the following codes. What does this mean P0420, P0217 and P1217. Thanks.

Rheem gas furnace slow to light [ 3 Answers ]

I have a Rheem model RGEB gas furnace this is a 90+ about 18 yrs old, the problem I am have is that the hot surface ignitor will come on and glow, but the gas valve will not turn on and after a few seconds the ignitor will cycle off, this will happen a few times and then the furnace may start. It...

View more questions Search