Ask Experts Questions for FREE Help !
Ask
    thom60's Avatar
    thom60 Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 14, 2007, 07:26 PM
    Wiring issue?
    I have replaced the low beam headlight (passenger side) on my '96 honda accord and it still won't come on. Both high beams and passenger side low beam went out at same time so I was skeptical that it was going to work. Im thinking I have a wiring problem. What is most likely cause? Or am I pi**ing in the wind? Thanks...
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    Dec 14, 2007, 08:10 PM
    . Check all under-dash and under-hood fuses with a test light or multimeter. Here's how:

    https://www.askmehelpdesk.com/cars-t...tml#post252145

    . Check for power in light socket, using a test light.

    . Replace Combination Light Switch:

    1. Disconnect negative battery cable.
    2. Remove lower dashboard cover (3 screws).
    3. Remove upper and lower steering column covers (3 screws).
    4. Disconnect 4-P and 7-P connectors from combination light switch, remove both screws, and lift out switch.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Duraglass pump wiring issue [ 6 Answers ]

I have a duraglass pump that is used and was wired direct. I bought it third party so I didn't cut the wiring. It has 3 wires: red blue and black, what is the most likely set up for these wires? Red-hot, black-ground, and blue-hot? I am wiring to red, black, and white. Thanks, Ty 230...

3 and 4 way switch wiring issue [ 1 Answers ]

I purchased a Leviton PR 180 motion activated light control, but was wondering if this could be wired to replace the current 4 way throw switch in its current location. The current 4 way switch is in a 3-switch configuration, but was placed in a location where a motion sensor would work better. ...

Simple HVAC wiring issue [ 10 Answers ]

I am switching from Honeywell CT87a (subbase Q539A4034) to Honeywell RTH7400 seems simple enough but I am bad when it comes to this sort of stuff. Anyway. I have Red, White, Green, Blue wiring coming out of the wall and have a electric air/heat system. Currently wired to 7400 as R-R W-Y B-W...

Thermostat wiring issue [ 2 Answers ]

I have installed a new condensing unit and cannot get it to turn on or the furnace to operate in the heat mode. What voltage reading should I expect at the thermostat? I do not seem to be reading 24 volts and am not sure if it is the transformer as I did not touch it. I am wondering if the...

Wiring issue with a Hunter Ceiling fan [ 2 Answers ]

Thanks in advance for anyone who can help me. I just moved into a brand new home and the Master Bedroom is pre-wired for a ceiling fan. It has two wall switches, one to control the light and one for the fan. The Hunter fan has a black, a white, a black/white and two green wires. The prewire...


View more questions Search