 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I sand the surfaces with 60grit just to open the pores of the pvc so the cleaner/softner will work better. Then apply the cleaner/softner, after that I glue, twist 1 quarter turn and hold in place for 60seconds, I wait until its complety cured before appling any pressure. Careful not to permit any glue or cleaner to drip on any threads or any surfaces that you don't want it. Glue will dry there and be a problem latter.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Can I use brass compression fittings with 15mm plastic pipe? Thanks!
I need to install a new shower valve but have no experience sweating copper pipe. Is it possible to use one of the new plastic pipe materials/methods to connect? I would have to use plastic on both the inlet and outlet sides of the valve. Thanks in advance for any advice, thoughts, ideas.
The pvc nipple on the intake of my shallow well pump was leaking. I cut the 1 1/4 inch pipe and was going to couple in a new nipple. The coupling would not fit the old pipe. It is white 1 1/4 " and so is my replacement pipe. I showed it to three different hardware stores and none of them could...
Hi: What are "approved coatings" for buried LPG gas pipe black iron fittings. The code only alludes to approved, but doesn't specify. In the Old days, it was 4 layers of 10-mil pipe wrap. but I'm wondering if there is some sort of liquid coating that can be applied (such as alphalt...
comic sans ms5 Hi I'm very new to forums so I don't know if I'm even in the right place so please forgive my mistakes hopefully I'll learn how to do this without losing my sanity or driving anyone crazy. So here is my question I need to know if it is possible to glue copper pipe I don't like...
View more questions Search
|
