 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Pull off about 15' of line, hold one end about 4" longer than the other, go to the middle and begin winding. at the end of the line when you have about 8" or so on each, hook into the knotches, and feed the line through the head's holes. Then tighten everything up.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
What is the gas to oil mixture for a 30cc homelite trimmer?
My homelite trimmer will start in half choke, but when set to the run position it dies out. It also sounds underpowered and takes a few seconds to get up to speed. Any ideas, I will be more than happy to take them.
We have continually had trouble starting our homelite gas trimmer and finally it will not start not matter what changes we make in the settings'
I let my neighbor borrow my weed trimmer. Now it will not feed line. I use to could bump it on ground and it would automatically feed line. Could he had taken trimmer end apart and lost something? All there is is a spring under trimmer head.
I can't figure out how to remove the metal cylinder (where rod goes) so I can remove orange housing - and reach cord to replace. On top of cylinder is a piece that looks like it might have star screw down inside of it. Any help would be appreciated. Cyn
View more questions Search
|
