Ask Experts Questions for FREE Help !
Ask
    Jasonk10's Avatar
    Jasonk10 Posts: 2, Reputation: 1
    New Member
     
    #1

    Nov 12, 2007, 05:17 AM
    Removing abs pipes
    How do you take apart abs pipes that were glued wrong?
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
     
    #2

    Nov 12, 2007, 05:27 AM
    You don't. You cut apart and start over.
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #3

    Nov 12, 2007, 06:06 AM
    Quote Originally Posted by Jasonk10
    How do you take apart abs pipes that were glued wrong?
    Keepitsimples answer
    You don't. You cut apart and start over.
    was bang on. It's more of a weld then a glue joint. The glue will melt the plastic until it forms one piece before it hardens. When that happens it's impossible to pull them apart. Regards, tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Removing glued ABS fitting to ABS piping [ 5 Answers ]

I glued an ABS toilet flange to ab ABS pipe roughing. The fitting did not go down all the way and is 1/2" proud of the tile flooring. I now want to remove the fitting and replace with a new fitting. How do I do it without damaging the receiving pipe. Pipe is in concrete floor. Thanks, Bob

Removing faucet handle after removing screw on top [ 7 Answers ]

My hot water is leaking.. I remove the top screw on the handle; the handle won`t come off.. should I try and pry it off or is there another screw somewhere that I don`t know about? This is a two handle-one spout faucet.

Frozen pipes - detecting burst pipes [ 1 Answers ]

Cold side of the kitchen faucet was frozen this a.m. Trickle returned this evening, followed by an immediate drop in hot faucet pressure - then some brownish water - the brownish water lasted 20 seconds - but the pressure is still low 1/3 pressure now and can get both some hot and some cold Have...

Removing Pipes [ 5 Answers ]

I am replacing a bathtub in my home. The water spout just keeps spinning on the pipe nipple. I was going to replace the pipe nipple but it looks like both ends have major corrosion going on. I cannot unscrew the nipple from the tee fitting. Any suggestions on loosening these parts so I can...

Abs pvc pipes [ 1 Answers ]

I'm redesigning my bathroom, and noticed that I have ABS pipes. The home depot don't sell any ABS supplies, but I was told that I could use the PVC instead. The guy over at Home depot seemed not to know much about plumbing. My question would be if I connect ABS with PVC is there any issues, or any...


View more questions Search