Ask Experts Questions for FREE Help !
Ask
    FVeilleux's Avatar
    FVeilleux Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 11, 2007, 11:56 AM
    Heating weil mclain furnace
    My furnace burner don't want to start by imself
    If I push the reset buton the burner start for 45 second
    That it I need to keep pushing the button for burner to start
    What is my propleme, why do the burner don't want to start
    By imself?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Nov 11, 2007, 05:20 PM
    Is this oil? If it is call for service you need a complete tune up.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Weil Mclain Ultra II 230 Boiler [ 25 Answers ]

I am considering a Ultra 230 boiler and in looking over the documentation I have three questions: 1. What the heck is a "condensing" boiler? 2. Will this boiler system work with cast iron radiators? 3. The piping diagram shows a 12" long connection atop the boiler between the input and...

Weil-Mclean oil burning furnace [ 4 Answers ]

The hot water radiators in two of my four zones heating my home are not getting hot even after increasing their thermostats to 80 degrees F. If there is a bubble in the circulating pipes how and from where do I bleed the system? I have a relatively new Weil-Mclean furnace (three years old). Thanks!

Weil maclean furnace [ 6 Answers ]

Have a 3 zone heating high efficiency gas. Lately furnace will turn off and won't turn on again until temperature in house reaches 60 degrees. Also, all 3 zones will not work at once. Have tried rotating thermostats and no differences. Have had furnace worked on numerous times and with no...

Heating Furnace [ 1 Answers ]

Our gas heater does not seem to stay on. We have the temperature set with a timer and to a certain temperature. The heater starts in the morning at the given time, but turns of a couple seconds later, than starts again, turns of again, and this goes on and on. Which part of the heater need to be...

Furnace not heating [ 1 Answers ]

I have a Carrier furnace with an automatic ignition. The fan is constantly running but it is not heating. I had this problem before and a tech came out and reset it but I cannot remember what he did. I cleaned the permanent filter and replaced it and I am getting a LED code 33 which states "Limit...

View more questions Search