Ask Experts Questions for FREE Help !
Ask
    traumat's Avatar
    traumat Posts: 5, Reputation: 1
    New Member
    		  
    #1

    Nov 9, 2007, 03:08 PM
    Kenmore washer no water but aggitator works
    I have a Kenmore 90 model #110.20922990 top load washing machine. I have had no trouble until today. I finished a load as normal. Now the next load, the water will not enter the machine. The machine starts right into aggitation as if it had water. I am assuming it is the "water pressure switch"? If so, is there a way to check it? The water is on, there are no blocks in the line coming in.
    Thanks Ted
    applsvcgirl's Avatar
    applsvcgirl Posts: 112, Reputation: 9
    Junior Member
    		  
    #2

    Nov 9, 2007, 03:41 PM
    Un clip the 2 front endcaps from the top of the panel. Now remove the 2 exposed screws that hold the panel to the top. The panel can now tilt back. The pressure switch hose can be removed from the pressure switch. Blow into the hose. You should get no resistance. Re attach it and try and start the machine and see if it works properly. If it doesn't you need a new pressure switch.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore Washer sometimes won't spin and drain water [ 2 Answers ]

Kenmore washer model 110.29812890 washes fine and sometimes it spins and drains the water out and sometimes it does not. Would this be the lid switch and if so, can I replace it myself without it being a major pain? I would appreciate any help and guidance if you think it is the lid switch so I...

Kenmore Elite washer leaking water [ 1 Answers ]

My kenmore Elite Washer is leaking water from back. It is not from any of the tubes ( hot, cold water and drain tube are all dry). It is from black hole on the back. It starts to leak water when it is in the washer cycle about 5-7 minutes. I have tried for small load to make sure it is not...

Kenmore washer still has water after spin cycle [ 1 Answers ]

I have a Kenmore washer 80 series model 110, After the spin cycle finishes there is still some water in the washing machine. We restart the cycle and then all the water is gone. This doesn't always happen, sometimes it works fine. Any ideas would be appreciated

View more questions Search