Ask Experts Questions for FREE Help !
Ask
    rwebud's Avatar
    rwebud Posts: 4, Reputation: 1
    New Member
     
    #1

    Nov 9, 2007, 11:19 AM
    Tempstar experts?
    Blower stay on even thermostat is disconnected at the board. Replace board but it's still doing the same thing.
    tsa7man's Avatar
    tsa7man Posts: 154, Reputation: 9
    Junior Member
     
    #2

    Nov 9, 2007, 12:18 PM
    Post the model number of your unit... Thanks..
    tsa7man's Avatar
    tsa7man Posts: 154, Reputation: 9
    Junior Member
     
    #3

    Nov 9, 2007, 12:22 PM
    Quote Originally Posted by rwebud
    Blower stay on even thermostat is disconnected at the board. Replace board but it's still doing the same thing.
    Until you post the model number, check the roll out switches, next to the burners... there is a little red button to push in to reset them, the problem could also be a stuck fan relay on the board... turn off the power and then turn it back on and see if the blower is now off. BUT the question here really is, if the problem is one of the roll out switches,. why did it trip out? Post your finding back on this site...

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

New $6,000 tempstar won't work [ 51 Answers ]

I have just purchased a new Tempstar 4 ton 13 seer, 78 afeu 1410A refrigerant. Model # PGX 348080K01A1. I had this thing installed in January, the heater worked fine. The ac won't work right. The guy that installed it has been here 5 times. He is at a loss as to what the problem is. The air...

Tempstar Furnace [ 2 Answers ]

I have a gas Tempstar furnace , The pilot ignites but the furnace does not it tries a few times then stops. The blower works . What might the problem be?

Tempstar furnace [ 6 Answers ]

I have an 80+ tempstar with the smartvalve gas valve. During the call for heat, the inducer motor starts, but the ignitor will not come on and light. I checked the ignitor and it is good. I checked for voltage and it is good. Could the gas valve be bad, since the ignitor is controlled by the valve...

Tempstar 5000 [ 1 Answers ]

I have a Tempstar 5000 A/C unit and would like to know the condenser size It's model # is ca5536uka1 so should I assume it is a 3 ton unit? Thanks Erik

Tempstar 5000 [ 3 Answers ]

I have changed the coil because it looks like it had a spark or got hot because there was black soot on the power terminals so I replaced it but it still doesn't work. When you turn it on there is a small hum the magnets are not being pulled in, when you push them in humming gets louder from the...


View more questions Search