Ask Experts Questions for FREE Help !
Ask
    inge's Avatar
    inge Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 5, 2007, 02:23 PM
    Installing vanity light
    I am installing vanity lights in a bathroom and the kit comes with 2 mounting plates: one level with 2 holes for screws and 2 one inch slots for screws, the 2nd is level on the 2 sides with the center inch being approx 1/2" deeper that the 2 sides. Do I need to install both the mounting plates? The instructions make no mention of a 2nd plate.
    Thank you
    Inge
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Nov 5, 2007, 03:15 PM
    You are given two different plates because they are sure of the box you have. You can use whichever one fits best. A picture would help.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bathroom Vanity Light Height.. [ 2 Answers ]

Hello again, everyone! Would anyone please tell me what a good "standard" height is for a vanity light, whether it be a single sconce or a 3-light wall-mount fixture? Any suggestions extremely appreciated! Is there any "rule of thumb?" :confused:

Can not hook up new Vanity Light [ 6 Answers ]

Hello, I have a major problem. The vanity light in my bathroom a few days ago just fell off the wall. It was cheap wood and the guy who we bought the house from put it in. Some things are strange in the house like the hallway plugin only will work with nightlights and such, vacuum will not...

Vanity Light [ 1 Answers ]

Recently I changed the vanity light in the bathroom. When I turned on the light I realized the breaker had tripped. I reset the breaker and all was fine for a couple days... the breaker tripped again. So I reset it and the same thing... 2 days later it tripped. I removed the light and can find...

Vanity Light Troubleshooting [ 3 Answers ]

I have a six-bulb vanity light bar in my bathroom. One of the lights will not work even with a new bulb installed. How do I disassemble the light fixture to determine if there is a loose wire? I do not see any screws that hold the decorative piece in place, so any information on how these...

Installing New Vanity and Need Help [ 5 Answers ]

We are remodeling our bathroom and have purchased a new vanity w/ bottom pull out drawer. The problem I now see is that the p trap portion of the drain is too low. We don't want to cut the vanity and I would like to avoid tearing the wall apart to raise the drain pipe inside the wall. Is it...

View more questions Search