Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Share bathroom and kitchen exhaust vent
[ 7 Answers ]
Hi, I am trying to put in an exhaust vent for my bathroom in the basement. I have two questions. First, does the roughed in usually have the trap pre-installed for the shower under the floor? Second, Can I run the bathroom vent to the kitchen exhaust pipe and have it run to the outside. In...
Replacing/repairing Veneer
[ 1 Answers ]
Hello! I just purchased a secretary from a second hand store. I am not sure of the wood; however, it is a majestic and heavy piece. I noticed on the drawer fronts that they are veneer and are not in good shape. I'm thinking about removing the veneer and replacing it. Is this something a novice...
Exhaust vent boot installation
[ 1 Answers ]
Recently I was in my attic & noticed water damage located right below a vent stack. I checked the exterior boot & noticed the bottom portion of the boot flashing was nailed down. Is this proper installation to nail the bootom portion of the rubber boot flashing? Should it only be caulked?? ...
Vent Stack boot on roof
[ 4 Answers ]
Installing new DWV system, finally ready to cut the stack through the roof. The flashing/boot that I bought says "do not caulk". I assume that means don't use caulk around the neoprene gasket that seals around the stack pipe, makes sense to me. But what about the flat underside of the aluminum...
Exhaust vent
[ 4 Answers ]
We have a new furnace located in the basement with a PVC exhaust pipe. The exhaust exits the house through the wall at the floor joists and is turned down toward the ground with a 90 degree elbow. Is this a common practice? I just assumed that it would exhaust through the roof as the old systems... View more questions Search
|